Blocked Triggers - SeaDoo Seascooter RS1 User Manual

Blocked triggers

If not washed properly, sand, salt or grit build-up could harm the operation trigger mechanism. Please follow below maintenance instruction:
1. Pull out the triggers button and remove the rubber cap located at the bottom of the handle. (See Fig.37)
2. Spray and flush water into the triggers, or the Rubber cap holes to clear any debris. (See Fig.38)
3. Put the Triggers and the Locking Buttons back in position and test if they operate smoothly.
4. MAKE SURE to put the Rubber caps back in position before use.
15
rubber cap rubber cap
Trigger button Trigger button
37 38