Midi Channels - Disaster Area Design SMARTClock Manual

MIDI P rograms a nd B PM P resets
The SMARTClock is designed to listen for incoming MIDI Program Change messages. Each time it
receives a Program Change message, the controller will access the tempo and subdivision settings
saved t o t hat m emory l ocation a nd s tart i ts i nternal c lock.
If an external MIDI controller is used, the Tap Tempo mode may be used for editing and saving all
presets. T o e dit a B PM p reset o n t he S MARTClock, s imply s
To e dit a B PM p reset o n t he S MARTClock:
Send a Program Change message from your external controller while in Tap Tempo mode. The
SMARTClock d isplay w ill s how t he p reset n umber a nd t hen r evert t o t he t empo.
Tap t he f ootswitch o r t urn t he e ncoder t o s elect t he n ew t empo.
Tap t he e ncoder t o e dit t he s ubdivisions f or e ach T empo O utput. I f t he T empo O utputs a re s et t o O FF
in the Setup Menu, they will be ON / closed if the subdivision is set to any value other than Wh /
whole n ote.
Hold t he f ootswitch t o s ave t he c urrent s ettings t o t he c urrent p reset.
MIDI C hannels
The S MARTClock s ends a nd r eceives b y d efault o n M IDI c hannel 1 6. T his v alue m ay b e e dited i n t he
Setup Menu if desired. MIDI Clock messages are sent on ALL MIDI channels, no channel assignment
for c lock s ignals.
Many Disaster Area controllers have a special channel designed to work with the SMARTPedal and
EZ series units. Setting the SMARTClock to this channel allows the other device to control the
SMARTClock w ithout u sing u p o ne o f t he " mappable" M IDI c hannels.
DPC-­‐5 MIDI C hannel 1
DMC-­‐3XL G en2 / D MC-­‐4 G en2 M IDI C hannel 1 6 ( v2.00 f irmware a nd h igher o nly.)
DMC-­‐6D M IDI C hannel 4
DMC-­‐8D M IDI C hannel 5