Canon Legria FS20 Instruction Manual page 98

Additional Information
THE CAMCORDER IS SET TO PHOTO MODE
- You pressed
THE CARD IS SET FOR ERASURE PREVENTION
- The LOCK switch on the SD or SDHC memory card is set to prevent accidental erasure. Change the position of
the LOCK switch.
THE MEMORY CARD COVER IS OPEN
- After inserting a memory card, close the memory card slot cover (
THIS PHOTO COULD NOT BE DELETED
- Protected photos cannot be deleted. Cancel the protection setting before deleting.
TOO MANY PHOTOS DISCONNECT USB CABLE
- Disconnect the USB cable and decrease the number of photos on the memory card to fewer than 1,800.
If a dialog box appeared on the computer screen, close it. Disconnect the USB cable, and restore the
connection after a short while.
TRANSFER ORDER ERROR
- You attempted to set more than 998 transfer orders. Reduce the number of photos marked with transfer
orders.
UNABLE TO RECOGNIZE THE DATA
- A memory card with data recorded in a different television system (NTSC) was inserted into the camcorder.
UNABLE TO RECOVER DATA
- Could not recover a corrupted file.
WHILE THE CAMCORDER IS CONNECTED TO A PC DO NOT DISCONNECT THE USB CABLE OR POWER SOURCE
CANNOT TURN OFF POWER OR CHANGE MODES
- When the camcorder is in
cannot be operated. Disconnecting the USB cable or power source while this message appears may result in
permanent loss of the recordings in the camcorder. Use the computer's Safely Remove Hardware function to
end the connection and disconnect the USB cable before using the camcorder.
Downloaded From VideoCamera-Manual.com Manuals
98
Start/Stop while the camera mode dial was set to
mode and is connected to the computer with a USB cable, the camcorder
.
28).