Canon Legria FS20 Instruction Manual page 94

Additional Information
The computer doesn't recognize the camcorder even though the camcorder is connected correctly.
- [USB SETTING] is set to [DVD BURNER]. Set it to [PC/PRINTER] or to [CONNECT&SET] (
- Disconnect the USB cable and turn off the camcorder. After a short while, turn it on again and restore the
connection.
The printer is not working even though the camcorder and printer are connected correctly.
- [USB SETTING] is set to [DVD BURNER]. Set it to [PC/PRINTER] or to [CONNECT&SET] (
- Disconnect the USB cable. Turn the printer off and then on again and restore the connection.
The camcorder doesn't recognize the DW-100 DVD Burner even though it is connected correctly.
- [USB SETTING] is set to [PC/PRINTER]. Set it to [DVD BURNER] or to [CONNECT&SET] (
List of Messages
Following the list of messages for the camcorder you can find separate lists for
printing-related messages (
the optional DW-100 DVD Burner (
ACCESSING THE CARD DO NOT REMOVE THE CARD
- You opened the memory card slot cover while the camcorder was accessing the memory card or the
camcorder started accessing the memory card as you opened the memory card slot cover. Do not remove the
memory card until this message disappears.
BACK UP RECORDINGS REGULARLY
- This message may appear when you turn on the camcorder. In the event of a malfunction, recordings may be
lost so back up your recordings regularly (
BUFFER OVERFLOW RECORDING WAS STOPPED
- The data transfer rate was too high for the memory card in use and the recording was stopped. Replace the
memory card with one rated Speed Class 2 or higher.
/
- There is a problem that prevents accessing the built-in memory. Initialize the built-in memory with this
camcorder (
/
- The built-in memory could not be read. This may indicate a problem with the camcorder. Consult a Canon
Service Center.
/
- The built-in memory is full ([
some space.
/
- There is a problem with the built-in memory.
CANNOT COMMUNICATE WITH THE BATTERY PACK CONTINUE USING THIS BATTERY PACK?
- You attached a battery pack that is not recommended by Canon for use with this camcorder.
Downloaded From VideoCamera-Manual.com Manuals
94
(in alphabetical order)
100) and for messages that appear only when using
/ BUILT-IN MEM INITIALIZE USING ONLY THE CAMCORDER
29).
/ BUILT-IN MEMORY ERROR
/ BUILT-IN MEMORY FULL
END] appears on the screen). Delete some recordings (
/ CANNOT ACCESS THE BUILT-IN MEMORY
99).
74).
87).
87).
87).
40, 62) to free