Invacare Action 4NG series User Manual page 26

- Comfort seat (photo 18)
It is removable allowing the folding of the wheelchair ;
simply lift the cushion and put it away, then grab the two seat
holding tubes and pull them upwards.
Repeat the operation in reverse order to unfold the wheel-
chair (see paragraph 2.1.1).
The padding and outer cover of this seat will wear; please
contact your dealer for possible replacement.
Make sure the cushion is properly positioned on the 3 seat
Velcro fasteners to provide safety and comfort for the user.
Keep your fingers away from movable parts to prevent injuries
during folding and unfolding !
24
- Comfort backrest (photos 19 & 19A)
It is made up of a rigid shell (A) and a preformed foam
cushion (B) which is locked in place by Velcro fasteners thus
providing optimal comfort.The backrest is removable to allow
the folding of the wheelchair; loosen both buttons (C), slide
the levers (D) to the inside and disengage the hooks (E) from
their supports. Reverse the procedure to reassemble the
backrest.
A
B
D
19A
19
It is recommended that this operation be performed only
by the attendant.Always make sure that the backrest is locked
in place for optimal safety of the user.
Make sure the backrest cushion Velcro fasteners are in good
state and well positioned. Keep your fingers away from mov-
able parts to prevent injuries.
Note : If you want to use the recliner function, please ensure
that the lateral belts are remove from theirs front side and
backrest supports.
Note : for maintenance of your DARTEX
soft rag soaked with alcohol.
- Comfort headrest (photo 20)
It is removable, completely loosen the ball screw (A). It is
height adjustable, slightly loosen the ball screw (A), adjust to
the desired height, tighten without forcing.
The cushion also is angle, depth and height adjustable by oper-
ating simultaneously the lever (B) and screws (C).
C
B
A
C
E
20
®
cover, only use a