Operation - Dimplex DWF3651 Owner's Manual

Operation

Figure 9
Floating
Display
TM
The unit can be controlled by
either the manual controls which
are located on the right side of the
fireplace or the remote (Figure 9
& 10).
The fireplace is supplied with an
IR multifunction remote control.
! NOTE: To operate correctly,
the remote control must be point-
ed towards the Floating Display
! NOTE: Before attempting any
operation with the remote, pull
the plastic insulator strip out from
between the remote casing and
battery cover.
A. Standby
Turns the unit On and Off.
→ Activated by pressing the
Standby button on the remote
or the unit.
• The unit will turn on with the
same functions that it was set
to when it was turned Off and
the intake temperature will be
indicated on the On Screen
Display.
! NOTE: If the unit is turned off
when the flame effect is Off, when
the unit is turned back on the
flame will be restored.
! NOTE: When any button is
.
TM
pressed the intake tempera-
ture will be displayed on the On
Screen Display for 5 seconds.
B. Flame Effects
Turns the flame effect On and Off.
→ Activated by pressing the
button on the remote.
C. Heat ON/OFF
Cycles the unit sequentially
through the 3 settings: Low Heat,
Figure 10
A
A
B
C
D
D
E
F
F
C
E
G
H
11