Remote Start Operation; Safe Start; To Operate The Vehicle While Running On The Remote Start; Temporary Stop Feature - Marksman M8a User Manual

Automotive security and remote start system

Hide thumbs Also See for M8a:

Installation manual (32 pages)

Table Of Contents

Table of Contents

To Remote Start the Vehicle

1. Press the

button twice on the transmitter.

2. The parking lights will be activated, indicating the remote start received the signal.

3. The engine will start approximately 5 seconds.

4. Once the engine is running, after a couple seconds the parking light will turn on again and

climate controls will activate and adjust the vehicles interior temperature to your preset setting.

5. The vehicle will run for a 5 to 30 minute cycle and automatically shut down.

Note: The Remote Start Unit will not start the vehicle if any one of the following conditions exist:

A. The hood is opened.

B. The brake pedal is pressed.

C. Move the optional remote start enable switch to "OFF" position (If installed).

D. The gear selector is in any gear other then "PARK" or "NEUTRAL".

Actions of the 2-Way LED Remote Control Transceiver

Activate Remote Start

Engine Running

Stop The Remote Start

Safe Start

(Also See Installation Manual)

Press the

button twice on the transmitter to start the vehicle (factory default setting). If your

transmitter has been programmed to the "Safe Start" feature, press the

same time to remotely start the vehicle.

To Operate the Vehicle While Running on the Remote Start

1. Insert the ignition key and turn it to "ON" (not the start) position.

2. Press the brake pedal.

Note: If the brake pedal is pressed before the key is in the "ON" position, the engine will shut

down.

Temporary Stop Feature

This feature allows the vehicle to remain running after the key has been removed from the

ignition. It is useful when you wish to exit and lock the vehicle for short periods of time, but

would like to leave the motor running and the climate control on.

1. Before turning off the engine, press the

indicator will flash 3 times to confirm.

2. Turn the ignition key to the "OFF" position (the engine will stay running).

3. The engine will run until the pre-programmed time elapsed or shutdown input is received.