Parts, Tools, Materials
The following parts are supplied with the oven:
NOTE: Depending on your ventilation requirements, you may not use all of these parts.
Backdraft damper / duct connector
(for roof-venting or wall-venting installation)
Not Actual Size (2 pieces must be assembled as shown)
Two self - tapping screws - Actual Size
(for attaching the damper duct connector)
Four 1/4" x 2" lag screws - Actual Size
(for wall stud holes)
Two 1/4" x 3" bolts - Actual Size
(for securing to the upper cabinet)
NOTE: You need to install at least two lag screws into a 2" x 4" stud and four anchor bolts into the wall.
The mounting area must meet the 150 lbs. weight requirement.
One power cord clamp bushing - Actual Size
(for the cord hole in a metal upper cabinet)
6
One power cord clamp and
One dark-colored mounting screw
(to hold the power cord)
Actual Size
One lock pin and one washer - Not Actual size
Four 1/4" x 3" toggle bolts - Actual Size
(for drywall holes)
Four spring toggle heads - Actual Size
(for the toggle bolts)