Maytag MMV1153AAW Installation Instructions Manual page 12

STEP 3: Prepare The Venting Blower
4. Reassemble the blower wire. See Figure 14.
5. Rotate the unit so that the exhaust ports face the rear of the cabinet. See Figure 15. When you insert blower unit,
blower wire must be like figure 15.
6. Place blower unit back into cabinet. Check that the exhaust ports face towards the rear of the cabinet. See Figure 16.
7. Reattach the blower plate to cabinet so the exhaust ports and blower plate opening are aligned. Attach with one blower
unit mounting screw and then one or two blower plate screw(s). See Figure 17.
Figure 14
Root-Vented Installation:
1. Remove one blower unit mounting screw and one or two
blower plate screw(s). Remove the blower plate from cabinet.
See Figure 18.
2. Use side cutter or thin snips to cut and remove parts "C"
from blower plate. Discard parts "C". Be careful not to distort
the plate. See Figure 19.
3. Carefully lift the blower unit out of the microwave oven.
4. Rotate blower unit 90° so the exhaust ports face the upper of
the cabinet. See Figure 20.
5. Reassemble the blower wire. See Figure 14.
6. Place blower unit back into microwave oven.
7. Reat tach blower plate to microwave oven. Attach with the one
blower unit screw and then the one or two blower plate screw(s).
See Figure 21.
8. Attach the exhaust adapter to the blower plate by sliding it into
the Guide. See Figure 22.
Figure 20
blower
unit
exhaust
ports
Figure 15
blower plate
back plate
mounting screw
parts "B"
Figure 21
12
exhaust
ports
Figure 16
Blower plate screw
Blower unit
Blower unit
mounting screw
Blower unit
exhaust ports
Figure 17
Blower plate screw
mounting screw
Figure 18
Knock out Parts "C"
Parts "C"
blower plate
Figure 19
Blower plate
Back plate