Specifications - M2TECH VAN DER GRAAF User Manual

VAN DER GRAAF
VERY LOW NOISE POWER SUPPLY
REVISION P A – JUNE 2014
R

8. Specifications

Output voltage: ................................. 9V
Output current:.................................. 500mA (outputs 1 and 2)
Noise:................................................ 2.9uVrms (20Hz-20kHz, A weighted, rated load
Outputs: ............................................ 5.5/2.1mm jacks, positive on tip (outputs 1 and 2)
Input voltage: .................................... 90-260V
Power consumption: ......................... 60VA
Fuse:................................................. slow blow 2.5A
Input:................................................. IEC socket with fuse holder and EMI filter
Output voltage selection: .................. by DIP-switches on back panel
Outputs activation: ............................ sequence set by user
Output reset: ..................................... inverse sequence with regards to activation
Size:.................................................. 200x50x200mm (w x h x d)
Weight............................................... 2.2kg (device only)
* maximum total current available on each of the two outputs rails is 1,5A
or 15V (outputs 1 and 2)
DC DC
+5V /+15V /-15V
DC DC
500mA (+5V, output 3 and 4)
1A (+/-15V, output 3 and 4)*
female 4-poles XLR (outputs 3 and 4)
, 50/60Hz
AC
3.5kg (packed)
22
M2Tech
www.m2tech.biz
(output 3 and 4)
DC
Copyright © 2014, M2Tech Srl