Advertisement
M10UM
2/20/02
12:26 PM
Valet Mode (System in Disarmed or Valet Mode)
The valet switch allows you to temporarily bypass all alarm function, eliminating the need to hand
your transmitter to parking attendants or garage mechanics. When the system is in valet mode, all
alarm function and remote start function are bypassed, however the remote panic feature and
remote door locks will remain operational. to use the valet mode, the system must first be disarmed
either by using your remote transmitter, or by operating the manual override sequence.
Remote Door Lock
Enter Valet Mode:
1. From the disarmed condition, turn the ignition to "ON" position.
2. Push and hold valet switch for 2 seconds until the LED turns on. The LED will remain on as
long as the system is in "valet mode".
Exit Valet Mode:
1. Return to normal operation, turn ignition "ON".
2. Push and hold valet switch for 2 seconds. The LED will turn off to indicate the system is
exiting the valet mode.
Car Locator
Press the (
) button to activate the car locator function. the siren will chirp 6 times. The parking
light will flash 12 times, for you to easily locate your car.
Panic Function
Panic Function: (See Alarm Feature Programming Part 1-7)
The transmitter can be used as a remote panic switch to manually trigger the alarm in case of
emergency.
1. Press and hold the (
2. During panic mode, the normal function of this transmitter button will be suspended. The
(
) and (
) buttons can be used to lock and unlock the doors (if the option is installed),
however on the (
will be enable allowing the vehicle to start.
3. To stop the alarm, press and hold the (
again for 3 seconds. Also in any transmitter button other than the (
(
) button is pressed and released, the panic mode will be turned off immediately.
4. If the button is not pressed, the alarm will automatically stop after 60 seconds.
Page 7
Remote Door Unlock
) button for 3 seconds. The alarm will immediately sound.
) button is pressed, the vehicle's starter disable device, (where installed)
) or (
) or (
) or (
) button on the transmitter
) or (
) or (
) or
7
Advertisement
