Supporting The Unit - JBL MR-145 Operation Manual

Controls
b. I-Vol
By pressing the select button again, the unit will be in the I- VOL mode. (Initial Volume
Level Adjustment). You can adjust the I-Vol by turning the spindle knob. After powering
the unit off and on again, the initial volume will match the I-VOL setting.
c. Area Selection
By pressing SEL button again, the unit will be in Area Selection mode. Use the spindle
knob to choose USA or EUR (Europe). Press and hold the BAND button for 1-2
seconds to set the format.
3.Volume control
Turn the spindle knob (2) left or right to decrease or increase the volume level.
Switching on your radio automatically allows you to set the volume level without
having to select it first. Simply turn the spindle knob to set the desired level.
- Bass control
Turn left to lower the bass.
Turn right to increase the bass.
- Treble control
Turn left to lower the treble.
Turn right to increase the treble.
- Balance control
Turn left to decrease the right speaker volume.
Turn right to increase the left speaker volume.
- Fader control
Turn left to decrease the volume level of any loud speakers connected to the front channel.
Turn right to decrease the volume level of any loud speakers connected to the rear channel.
4."MODE" Button(3)
Press this button to select radio, CD and AUX.
5. BD/LD Button(6)
This button works 2 functions.
a. Shortly press the BD/LD button to select the desired band FM1,FM2,FM3,AM1,AM2.
b. In order to emphasize the bass and the treble at low volume, press and hold the
BD/LD button for about 3 seconds. The display "LOUD" is indicated on the display.
To cancel loudness function, press and hold BD/LD again.
8

Supporting the unit

1. UNIT
2. HALF SLEEVE
3. HEX NUT
4. LOCK WASHER
5. PLAIN WASHER
6. BODY
7. REAR SUPPORT STRAP
8. TAPPING SCREW
9. M5 X 20 HEX BOLT
Accessories subject to change without notice.
1. Fuse replacement
If the fuse blows, check the power connection and replace the fuse. If the fuse blows
again after the replacement, there may be an internal malfunction. In this case,
consult your nearest dealer.
2. Warning
Use the specified amperage fuse for each lead.
Use of a higher amperage fuse may cause serious damage.
5