Dmx Address; Show Mode; Slave Mode - ADJ H20 DMX IR User Instructions

H2O DMX IR
On-Board System Menu.
navigate system menu. This next section will detail the functions of
each command in the system menu. Please read the next section
thoroughly!
To access the main menu press the MENU button. Press the UP or
DOWN buttons until you reach function you wish to change. When you
reach the function you wish to change press the ENTER button. When
a function is selected use the UP or DOWN buttons to change the func-
tion settings. Once your changes are made press the ENTER button,
and then press and hold the MENU button for at least three seconds
to confirm and lock the change into the system memory. If the MENU
button is not pressed and held within eight seconds the fixture will
automatically confirm and lock the change into the system memory. To
exit without making any changes press the MENU button.

DMX Address

- This will let you set your desired DMX
address.
1. Press the MENU button until "DMX Address" is displayed,
press ENTER.
2. The current DMX address will be displayed. Press the UP or
DOWN buttons to find your desired address.
3. Press ENTER to confirm, then connect your DMX controller.

Show Mode -

Show modes 1-3 (Factory programs).
Show mode can run with or without sound active mode
active.
1. Press the MENU button until "Show Mode" is displayed, press
ENTER.
2. "Show X" will now be displayed, "X" representing a number
between 1-3. Use the UP or DOWN buttons to find your desired
show.
3. When you have found your desired show press ENTER, then
ADJ Products, LLC - www.adj.com - H2O DMX IR Instruction Manual Page 8
System Menu
The H2O DMX IR comes with an easy to
H2O DMX IR
press and hold the MENU button for at least 3 seconds to acti-
vate. After you have set your desired show, it can be changed at
any time using the UP or DOWN buttons.

Slave Mode -

This will let you set unit as a master or
a slave in a master/slave configuration.
1. Press the MENU button until "Slave Mode" is displayed,
press ENTER. Either "Master", "Slave 1", "Slave 2" will be
displayed.
2. Press the UP or DOWN buttons until your desired setting is
displayed, press ENTER to confim.
DMX Last State
- This mode can be used as a precau-
tion mode, that in case the DMX signal is lost, interrupted, or
power is lost, the operating mode chosen in the setup is the
running mode the fixture will go into when the DMX signal is
lost. You can also set this as the operating mode you would
like the unit to return to when power is applied.
1. Press the MENU button until "DMX Last State" is displayed,
and press ENTER. The current last state setting will be displayed.
2. Use the UP or DOWN buttons to find a mode you would like
the unit to go into in case the DMX signal is lost.
• Last State - If the DMX signal is lost the fixture will stay in the
last DMX setting. If power is applied and this mode is set, the unit
will automatically go into the last DMX set up.
• Master Slave - If the DMX signal is lost or power is applied,
the unit will automatically go into Master Slave mode and run a
built-in show.
• Blackout - If the DMX signal is lost or interrupted, the unit will
automatically go into stand by mode.
3. Press ENTER to confirm your desired set up.
ADJ Products, LLC - www.adj.com - H2O DMX IR Instruction Manual Page 9
System Menu