Kenwood FP615 Instructions Manual page 6

before using your Kenwood appliance
Read these instructions carefully and retain for future reference.
G
Remove all packaging and any labels.
G
safety
The blades and discs are very sharp, handle with care. Always
G
hold the knife blade by the finger grip
away from the cutting edge, both when handling and
cleaning.
Always remove the knife blade before pouring contents from the
G
bowl.
Keep hands and utensils out of the processor bowl and liquidiser
G
jug whilst connected to the power supply.
Switch off and unplug:
G
before fitting or removing parts
G G
after use
G G
before cleaning
G G
Never use your fingers to push food down the feed tube. Always
G
use the pusher/s supplied.
Before removing the lid from the bowl or liquidiser from the
G
power unit:-
switch off;
G G
wait until the attachment/blades have completely stopped;
G G
Be careful not to unscrew the liquidiser jug from the blade
G G
unit.
Liquids should be allowed to cool to room temperature before
G
blending.
G This machine will be damaged and may cause injury
if the interlock mechanism is subjected to excessive
force.
Do not use the lid to operate the processor, always use the
G
on/off speed control.
Never use an unauthorised attachment.
G
G Never leave the machine on unattended.
Never use a damaged machine. Get it checked or repaired: see
G
'service'.
Never let the power unit, cord or plug get wet.
G
Don't let excess cord hang over the edge of a table or worktop
G
or touch hot surfaces.
This appliance is not intended for use by persons (including
G
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do not play
G
with the appliance.
Only use the appliance for its intended domestic use. Kenwood
G
will not accept any liability if the appliance is subject to improper
use, or failure to comply with these instructions.
Misuse of your processor/liquidiser can result in injury.
G
before plugging in
Make sure your electricity supply is the same as the one shown
G
on the underside of your machine.
Important – UK only
The wires in the cord are coloured as follows:
G
Blue = Neutral, Brown = Live.
at the top, The appliance must be protected by a 3A approved (BS1362)
G
fuse.
Note:
For non-rewireable plugs the fuse cover MUST be refitted when
G
replacing the fuse. If the fuse cover is lost then the plug must not
be used until a replacement can be obtained. The correct fuse
cover is identified by colour and a replacement may be obtained
from your Kenwood Authorised Repairer (see Service).
If a non-rewireable plug is cut off it must be DESTROYED
G
IMMEDIATELY. An electric shock hazard may arise if an
unwanted non-rewireable plug is inadvertently inserted into a
13A socket outlet.
This appliance conforms to EC directive 2004/108/EC on
G
Electromagnetic Compatibility and EC regulation no. 1935/2004
of 27/10/2004 on materials intended for contact with food.
before using for the first time
1 Remove all packaging including the plastic blade covers from the
knife blade. Take care the blades are very sharp. These
covers should be discarded as they are to protect the blade
during manufacture and transit only.
2 Wash the parts see 'cleaning'
key
processor
pushers
feed tube
lid
detachable drive shaft
bowl
safety interlock
cord storage (at back)
power unit
speed/pulse control
liquidiser outlet/interlock
liquidiser outlet cover/safety interlock
liquidiser
blade unit
sealing ring
jug
lid
filler cap
3