Monessen Hearth NB18 Installation Instructions Manual page 41

TOUCH SCREEN REMOTE CONTROL OPERATION - SCR MODELS
 Using the Mounting Base
The transmitter comes with a mounting base which allows
you to hang the transmitter on the wall.
1. Secure the mounting base on the wall with supplied
screws. For best viewing angle, make it the same
height as your eyes.
2. Hang the transmitter on the hook of the mounting
base, then push down so the transmitter is fl ush to the
mounting base.
Symptom
1. Battery icon on LCD on transmitter
2. LCD display is blank
3. LCD display shows "funny" display
4. Appliance does not come on
81D0107
Figure 60
TROUBLESHOOTING
Causes
1. Low Battery
2. The transmitter did not match
with the receiver
3. Transmitter measures temp-
erature exceeding 99 degrees
Fahrenheit and shows "HI" on
LCD
4. Distance between the
transmitter and receiver is
more than 30 feet
NB18/NB24 Gas Log Set
Action
1. Replace batteries. Change batteries
every 6 months.
2. Check battery installation or replace
batteries.
3. Reset the transmitter
(see "Resetting the Transmitter"
section).
1. Make sure the transmitter has
learned to the receiver.
1. Move transmitter to a cooler place
and wait until temperature drops
below 99 degrees.
1. Make sure the opening distance is
less than 30 feet.
41