Monessen Hearth NB18 Installation Instructions Manual page 38

NB18/NB24 Gas Log Set
Setting Privacy Code on Transmitter
Figure 52
The remote transmitter privacy
code is preset in factory. In the
event of activation or interfer-
ence from other nearby trans-
missions, change the code using
the following procedures (learn
function must be performed after
changing the code):
1. Press the ON/arrow button
and the TIMER button at the
same time to enter privacy
code setup mode.
2. The setup display is shown in
the fi gure. The four digits on
the top stand for the privacy
code. The default values of
the four digits will be all "1".
3. The fi rst digit will be fl ashing upon entering the setup
mode. Push the ON button to toggle its value between
"0" and "9", and push the "OFF" button to jump to the
next digit. The next digit will then start fl ashing and the
fi rst one stops fl ashing. Set up the four digits to your
choice between "0" and "9".
4. After setting up all the four digits, push "OFF" to fi nish
the process and return to the previous mode.
5. The Signature Command control board then needs to
re-learn the new setting.
Performing Learn Function
1. The RF receiver button on the control board in the
fi replace must be in the on position before the learn
function can begin (refer to fi gure for location). With
the Command Center master switch in the ON posi-
tion, use paper clip to depress the recessed button on
Control Board, one beep for RF receiver ON or two
beeps for RF receiver OFF.
2. Holding the OFF
button on the Com-
mand Center while
turning on the
master switch will
activate the learn
function for the
transmitter.
3. After the above op-
eration, two beeps
will be given and the
green LED on the
Command Center
will fl ash for 10 sec-
onds.
38
TOUCH SCREEN REMOTE CONTROL OPERATION - SCR MODELS
Figure 52
RF
Receiver
ON/OFF
Control
Board
Figure 53
ON
LED
Command
Center
OFF
Figure 54
Battery Door
Master Switch
4. During the 10 seconds, press the OFF button on the
transmitter to learn. Another two beeps will be given to
confi rm a successful learning.
Do not use two (2) or more remote control sys-
tems in the same area with the same privacy
code setting, as they will communicate with
each other. This may cause the appliances to
malfunction.
Resetting the transmitter
If the transmitter is not working properly, reinstall the bat-
teries to reset the transmitter.
1. Pull out at least one of the batteries.
2. Press any key on the screen to discharge.
3. Wait for 10 seconds and reinstall the batteries.
Pushing and holding any key for more than 10 seconds
until the display refreshes will also reset the transmitter.
 Functions and Operations
General
The TSTSC Remote Control has four (4) operating
modes: Manual, Timer, Thermostatic and Smart Mode.
The control system can be set to temperature range be-
tween 45° F and 90° F. The fl ame height can be adjusted
in the manual and thermostatic mode. The Smart Mode
will automatically adjust fl ame height according to the dif-
ference between Set and Room temperatures.
The transmitter will operate the remote receiver from 1
foot to a maximum of 30 feet. The distance is reduced
when batteries are low.
Manual Mode
Figure 55
In this mode, the TIMER/THERMO buttons will only dis-
play "TIMER" / "THERMO", without showing the time and
the SET temperature. Pressing the ON/up and OFF/down
buttons will change the fl ame height and turn on/off the
fi replace if the TIMER/THERMO buttons are not pressed
and fl ashing.
FP2650
81D0107