Installation and Operating
Instructions
waRnInGS
IF The InFoRMaTIon In TheSe InSTRuCTIonS
aRe noT FolloweD exaCTly, a FIRe
oR exploSIon May ReSulT CauSInG
pRopeRTy DaMaGe, peRSonal InjuRy oR
loSS oF lIFe.
–
Do not store or use gasoline or other
flammable vapors and liquids in the vicinity
of this or any other appliance.
–
whaT To Do IF you SMell GaS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not
use any phone in your building.
• Immediately call your gas supplier from
a neighbor's phone. Follow the gas
supplier's instructions.
• If you cannot reach your gas supplier, call
the fire department.
–
Installation and service must be performed
by a qualified installer, service agency or
the gas supplier.
waRnInG: Improper installation, adjustment,
alteration, services or maintenance can cause
injury or property damage. Refer to this manual.
For assistance or additional information
consult a qualified installer, service agency or
the gas supplier.
This appliance may be installed in an aftermarket*,
permanently located, manufactured home (uSa
only) or mobile home, where not prohibited by
local codes.
This appliance is only for use with the type of
gas indicated on the rating plate. This appliance
is not convertible for use with other gases,
unless a certified kit is used.
* aftermarket: Completion of sale, not for purpose of
resale, from the manufacturer.
CDVSC7 Series
CDV7 Series
Direct Vent Gas Fireplace
Models:
CDVR33n/pV7;n/pe7;n/pSC7, CDVT33n/pV7;n/pe7;n/pSC7,
CDVR36n/pV7;n/pe7;n/pSC7, CDVT36n/pV7;n/pe7;n/pSC7,
CDVR42n/pV7;n/pe7;n/pSC7, CDVT42n/pV7;n/pe7;n/pSC7,
CDVR47n/pV7;n/pe7;n/pSC7, CDVT47n/pV7;n/pe7;n/pSC7
Due To hIGh TeMpeRaTuReS, The applIanCe
ShoulD Be loCaTeD ouT oF TRaFFIC anD
away FRoM FuRnITuRe anD DRapeRIeS.
ChIlDRen anD aDulTS ShoulD Be aleRTeD
To The haZaRDS oF hIGh SuRFaCe
TeMpeRaTuRe anD ShoulD STay away To
aVoID BuRnS oR CloThInG IGnITIon.
younG ChIlDRen ShoulD Be SupeRVISeD
when They aRe In The SaMe RooM aS The
applIanCe.
CloThInG oR oTheR FlaMMaBle MaTeRIal
ShoulD noT Be plaCeD on oR neaR The
applIanCe.
Keep The RooM aRea CleaR anD FRee
FRoM CoMBuSTIBle MaTeRIalS, GaSolIne,
anD oTheR FlaMMaBle VapoRS anD
lIquIDS.
InSTalleR: leave this manual with the appliance.
ConSuMeR: Retain this manual for future refer-
ence.
CDVT
CDVR
693011
CDVRT7 cover
69D3011 8/10 Rev. 8
Need help?
Do you have a question about the CDV7 and is the answer not in the manual?
Questions and answers
How to change my CDVT36nsc7 form Standing to Intermitent
To change the Monessen Hearth CDVT36NSC7 from standing pilot to intermittent pilot:
1. Press and hold the ON button on the Command Center.
2. While holding the ON button, turn on the master switch.
3. The system will toggle between standing pilot and intermittent pilot.
4. A confirmation beep will sound:
- One beep for standing pilot
- Two beeps for intermittent pilot
This answer is automatically generated
My burner will light but go out after 30-45 seconds. The command center and cable have been replaced 2x as well as the thermopile/couple/pilot, the gas valve, and the control box but still no flame for more than a short while. The diagnostic box shows 2 Reds blink every 10 seconds which the manual says is “no or low thermopile power” but the pilot assembly was replaced 2 years ago and we don’t use it that much. I’ve had numerous repair people out to try and repair but to no avail.