Observations Before Transport Of Wheelchairs In Vehicles; Restraint Systems - Invacare Action NG User Manual

4.1. Observations before transport of wheelchairs in
vehicles
• We recommend that wheelchair users should transfer to the
seat of the vehicle and use the installed restraint system of
the vehicle whenever feasible.
• The wheelchairs are tested in a basic configuration.The use
in other configurations has not been tested. Please contact
your dealer for further information.
• Auxiliary wheelchair equipment is either secured to the
wheelchair or removed from the wheelchair and secured in
the vehicle during transit. (i.e. table trays).
• Alterations or substitutions are not to be made to points of
the wheelchair or to structural and frame parts without the
written consent of Invacare
®
• A wheelchair-anchored posture belt with metal buckle must
be fitted across the wheelchair occupant in addition to the lap
and diagonal occupant restraint (3-point belt).
• Belt restraints are not to be held away from the body by
wheelchair components or parts such as armrests, postural
restraints, wheels, etc. (Picture 22)
• The wheelchair must be securely fastened in the vehicle with
an ISO 10542-1:2012 approved 4-point belt system, according
to the methods described in the manual.
• The occupied wheelchair must be tied down in an forward-
facing position, with the parking brake applied.
• The wheelchair backrest should be positioned as close as
possible to 90 degrees.
Please observe that even if these products and
recommendations are provided in order to increase safety,
injury to vehicle occupants still might occur in the event of a
.
collision or other accidents and no guarantee is given in this
respect.
Correct and incorrect placements of 3-point belt
(picture 22).
4.2. Restraint systems (picture 23A, detail A)
* Non contractual picture, only for information !
Please refer to best practice recommended instructions from
the safety belt manufacturer.
A. Front restraints with straps (picture 23A & detail A)
1. Connect the front straps around the front part of the
frame. (See location of the attachment labels).
2. Release brakes and apply tension front straps by pulling the
wheelchair backwards from the rear.
3. Re-apply wheelchair brakes.
B. Rear restraints (pictures 23B for self propulsion & 23C
for Transit version)
1.Attach the snap hooks on the rear straps to the rear orange
ring (A) just below the backrest tube bracket.
2. If the chair is not equipped with orange rings, attach the
snape hooks on the rear straps to the frame just above the
rear wheel attachments.
3.Tighten the straps.
EN13