Body Solid WDIB46.2L Owner's Manual page 8

trtl l-l =f'
i74llI-*ff
: l l - l l . ' t ) I l { l I r r f t r j i
\
ASSEMBLY. STEP 3
**Nofe : Do Not fully tighten frame bolts and nuts until after completing Sfep 3
The following Parts and Hardware will be needed to complete Step 3
Parts Description
Aly
Part Part Description
1
I Leg Pivgt Frame
1 J
Leg Frame
2 M Short Frame Roller Bar
1 N Long Frame Roller Bar
Hardware Description
Aly
Part Part Description
6
A3 112" x3112" hex head bolt
82
1/2" nylon lock nut
C4
'112" round cap washer
D16 10 x 75L ring pin
D10 1 112" x 1 112" end cap
D11 1/2" bolt cap
D12 45x45 end cap
D13 1" round end cap
D14 1" rubber cane tip
D15 Foam rollers
Step by Step
1. Attach (J) - Leg Frame to (l) - Leg Pivot Frame
2. Attach (N) - Long Foam Roller Bar to (l) - Leg Pivot Frame
3. Attach 2 (M) - Short Foam Roller Bar to (J) - Leg Frame
4. Place 6 (D15) - Foam Roller on (N) - Long Foam Roller Bar and 2 (M) - Short Foam
Roller Bar
**Securely Tighten All Frame Bolts Used in Steps 3
..4.