Advertisement
2. Procedures for connecting the
MZ-l
F19 mini-floppy disk drive to the
MZ-800
are as follows.
1) Turn off the
MZ-800
and its peripheral units.
2) Install the optional mini-floppy disk interface
MZ-l E05
into the expansion
slot on the rear panel of the
MZ-800
or the
MZ-l U06
expansion unit
which is connected to the
MZ-800 (
1 ).
Note:
If the
ROM
chip which is attached to the
MZ-700
DISK BASIC is set in
the socket on the
MZ-l E05
circuit board, remove it.
3) By using the cable which is attached to the
MZ-l E05
mini-floppy disk
interface, connect the
MZ-l E05
interface to the upper connector on the
rear panel of the disk drive
(CID).
Then fasten the connectors with screws.
~
To the expansion slot of the
~
CD
MZ.sO~
or
th~
MZ·1U06
~
=~expanSlo(n ~:~::
)
The slot cover
(MZ-1 X 17)
is required in case the
o~
interface is installed into
MZ-1 E05
~
the expansion slot of the
CID
MZ.sOO.
Cable attached to the
MZ-1E05
-
4 -
Advertisement
