Handset & Hardware Care - Sharp AQUOS Xx User Manual

Handset & Hardware Care
Handset & Hardware Care
・Use handset within 5 C - 35 C and 35% - 90% humidity.
o o
・Avoid extreme temperature or direct sunlight.
・Handset/Internal Battery may become warm during operation
or while charging. This is normal.
・Warranty does not cover malfunctions resulting from
misuse.
・Clean handset with a soft dry cloth. Alcohol/solvent use
may fade color/print.
・Avoid scratching Display.
・Avoid heavy objects or excessive pressure. May cause
malfunction or injury.
・Do not sit on handset in back pants pocket.
・Do not place heavy objects on handset inside handbags,
packs, etc.
・Handset back cover is not removable. Do not try to remove
it; may cause damage or malfunction, or affect water
resistance.
・Connect only specified products to Port. Other devices may
malfunction or cause damage.
・Do not power off while using SD Card; may result in data
loss or malfunction.
・When walking outside, moderate handset volume to avoid
accidents.
・When holding handset, do not block Receiver, Mic, Speaker,
or Recorder Mic.
・Proximity Sensor prevents Touchscreen misoperation during
calls. Do not cover or place a sticker/label over Proximity
Sensor; Display may remain off during calls, disabling
handset operation.
・If your hair is between Receiver and your ear during calls,
Proximity Sensor may not function properly.
Display may remain on; touching Display accidentally may
end the call.
・Do not cover Light Sensor or place a sticker/label over it;
may hinder ambient light detection, resulting in malfunction
of Light Sensor.
・Handset Receiver is located at the center of Display upper
end. If other party's voice is hard to hear during calls, hold
handset so that Receiver is next to your earhole for better
audibility.
USIM/SD Card Slot
Use notch to open Card Slot Cover
Insert/remove USIM/SD Card
・SD Card Slot is located above USIM Card Slot. Insert each
card into correct opening in correct orientation.
・USIM Card Insertion/Removal
・Always power off before insertion/removal.
・Place USIM Card in USIM Tray beforehand.
・When removing USIM Tray, do not pull it forcefully or at
an angle; damage may result. Gently pull it out horizontally
from the edge.
・When inserting empty USIM Tray, do not insert it at an
angle; damage may result. Check orientation of USIM Tray,
then gently insert it all the way horizontally.
・SD Card Insertion/Removal
・Unmount SD Card beforehand.
・When removing SD Card, lightly push it in and release
finger (SD Card pops out slightly); gently pull it out
horizontally.
173