Sharp MZ-80B Basic Manual page 45

S command assigns a volume number t o a initialized diskette for making a slave diskette. Figure
2 . 5 shows an example where the slave diskette in drive 1 is made with volume number 2.5 assigned.
Any number from 1 through 1 2 7 can be specified for the volume number. Different numbers must
be assigned to each diskette so that a diskette can be specified with its volume number in a logical
open statement.
C command copies a diskette . The follo wing example copies the diskette in drive 1 on diskette in
drive 2 .
[ COMMAND TABLE ]
DISKETTE INIT
SLAVE-DISK INIT
D ISKETTE COPY
BOOT START
? s
VOLUME NO. 2 5
[ COMMAND TABLE]
DISKETTE INIT
SLAVE-DISK INIT
D ISKETTE COPY
BOOT START
? C
F ROM
DRIVE NO. 1
TO
DRIVE NO. 2
COPY
2.6 Slave diskette copying
FIGURE
I
S
C
B
2.5
FIGURE
I
S
C
B
3 7