Assigning Record Outputs - Mark Levinson N380S Owner's Manual

assigning record outputs

5 IF THE SOURCE IN QUESTION IS A RECORDABLE DEVICE...
Y ou will be further prompted to associate a particular
this particular device. Instead of showing "
" " as shown below.
RCD: NONE
Y ou may elect not to use either
may be the case if you have several devices in your system that are capable
of recording. In this case, leave the display on "
Step 6.
Y ou may also select either
particular input. To do so, press the input button repeatedly until you see
your choice of
OUT1
below.)
6 STORE YOUR SELECTION
Save your choice in nonvolatile memory by pressing and holding the Mode
button until the display reads
NEW DATA
record output
record output 1 or 2
or in the display . (
OUT2 OUT1
, as below.
NEW DATA
record output with
," the display will read
with this particular device, as
RCD: NONE " and move to
to be associated with this
is given as an example
21