Remote Control - Mark Levinson N380S Owner's Manual

R
MADRIGAL AUDIO LABORATORIES
1
mono polarity
2
display mode
1 2
3
3 4
5 6
4
volume mute
16

Remote Control

1 MONO
5
Pressing this button will toggle the Nº380S in and out of the
having the same effect as pressing the front panel
6
mode activates circuitry which combines Left and Right input signals, and
sends the resulting monophonic signal to both Left and Right outputs. This
circuit is particularly useful when listening to older, monophonic source ma-
terial, at which time significant noise reduction may be realized.
2 DISPLAY
7
Duplicates the function of the
cycling among four levels of brightness (including "off") for the display, al-
lowing adjustment for various ambient lighting conditions. (Tip: If pressed
and held for several seconds, the display button will place your Nº380S in
Standby.)
3 SOURCE SELECTION
These buttons provide remote selection of the six inputs of the Nº380S.
Pressing any of these buttons (or the
is in standby will bring it fully on and operational. These buttons are gray
instead of black to serve as a reminder of this secondary function.
4 VOLUME +/-
Raises the volume at either low speed for fine adjustments or high speeds
for larger changes. The Nº380S will slowly raise its output for the first 1.5
seconds this button is depressed, then move to higher rates of change.
Pressing either
it fully on and operational. These buttons are gray instead of black to serve
as a reminder of this secondary function.
Note that all volume and balance functions are disabled if a surround
sound processor ["ssp"] input is selected. For more information on this spe-
cial feature of the Nº380S' design, see "Using Surround Sound Processors."
5 POLARITY
Inverts the
polarity
outputs of the Nº380S. A second press of this button will restore the out-
puts to their original, non-inverting polarity .
6 MODE
Duplicates the function of the Mode button on the front panel, cycling
through
monitor, record select,
button, use it in conjunction with the Source Selection buttons when in ei-
ther monitor or
in mode.
balance
display intensity
volume +/-
button while the Nº380S is in standby will bring
volume +/-
(sometimes inaccurately called "absolute phase") of the
and
balance
record select mode and with the
mode,
mono
button. Mono
mono
button on the front panel,
buttons) while the Nº380S
modes. As with the front panel
volume +/- buttons when