Installing The Batteries To The Remote; Connect Power; Antenna Connection; Switching On/Off - Hitachi 50HYT62U Instruction Manual

Installing the Batteries to the Remote

1. Lift the cover on the back of the remote upward
gently.
2. Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity.
3. Replace the cover.

Connect Power

IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.

Antenna Connection

Connect the "aerial" plug to the AERIAL INPUT (ANT)
socket located on the back of the TV.

Switching On/Off

To Switch the TV On

Connect the power cord to the 220-240V AC, 50 Hz.
To switch on the TV from standby mode either:
Press the " " button, P+ / P- or a numeric button on
the remote control.
Press the side function switch until the TV comes on
from standby.

To Switch the TV Off

Press the " " button on the remote control or press
the side function switch until the TV switches into
standby mode.
To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched to standby mode, the standby
LED can blink to indicate that features such as Standby
Search, Over Air Download or Timer is active. The LED can
also blink when you switch on the TV from standby mode.
For any help concerning set up and use of your TV please call the Customer Helpline:

First Time Installation

When turned on for the first time, the "language
selection" menu appears. The message "Welcome
please select your language!" is displayed in all
language options listed alphabetically.
Press the "
language, press OK button to select. "First Time
Installation" appears. Use "
required country, and press "
Type. Use "
Available search types are Digital and analog, digital
only and analog only. When set, press "
Teletext Language. Use "
"Teletext Language" and select "Scan Encrypted" using
" " or "
Yes if you want to scan coded stations.
Default PIN code can change depending on the
selected country.
If you are asked to enter a PIN code for viewing a
menu option, use one of the following codes: 4725,
0000 or 1234.
Press OK button on the remote control to continue and
the following message will be displayed on the screen.
English - 12 -
" or " " button to highlight the required
" or "
" button to select Search
" or " " to set the desired search type.
" or "
" button. You can set Scan Encrypted as
0345 604 0105
" button to set the
" to select
" button to set the