Hobby 350 TB De Luxe Operation Manual page 20

1
2
3
4
3
Preparation for hitching/unhitching
•
To hitch and unhitch, open the tension ball
coupler (lever in position
WARNING: Ensure that the metal of
your ball coupler is bright and free of
grease.
Hitching
•
The open tension ball coupler is set onto the
coupling ball of the base vehicle.
The tension ball coupler usually closes by
applying downward pressure since the sup-
port load is sufficient (lever in position
When dealing with higher drawbar
loads hitching and unhitching is
simplified by the use of a support
wheel.
Inspection of hitch
•
The ball coupling is closed when the lever
k
rests in position
of the hitching display
If the WS 3000 is not properly at-
tached to the coupling ball, the
camper can detach from the base
vehicle.
Activation of the stabilization system
•
To activate the stabilization system, the
operation lever must be moved downward out
of the closed position
The spring corpus will become tense in the
process, so that contact pressure is created
on the coupling ball via the friction elements.
Afterward, the operation lever lies approxi-
mately parallel to the drawbar axle.
Shutoff of the stabilization system
•
Bring the operation lever slowly upward into
the open position (position
system.
Although it is possible to drive wi-
thout activating the stabilizing device,
e.g. when shunting, we do not re-
commend that you do so.
j
).
k
).
l
or and the green pin
m
is visible.
k l
until it locks in
k
) to shut off the
03-3
.