Kenwood DDX7015BT Instruction Manual page 69

CONNECTION/INSTALLATION CONNECTION/INSTALLATION
Connecting wires to terminals for Toyota Cars (for DDX715WBT)
Pages 70 – 71
USB terminal (0.8 m):
Pages 70 – 71
Connect the antenna
cord to the antenna
terminal.
1
Blue with white stripe
(Power control wire)
Brown (Mute control wire)
*
2
7
* If no connections are made, do not let the cable come out from the tab.
1
*
2 When using Antenna Control, connect ANT CONT lead (blue) to A5 (blue) on the wiring harness.
Page 72
Pages 70 – 71
*
1
When using the optional power amplifier, connect
to its power control terminal.
Not used.
Connector B
Connect to vehicle's harness.
Connector A
Connect to vehicle's harness.
Connector C
Connect to vehicle's harness.
C5
• Depending on the type of vehicle, it
cannot be connected. In this case, connect
the JASO plug directly to the unit.
Connector D
D21
8
Purple with white stripe
(Reverse sensor wire)
Light green (Parking
10 A fuse sensor wire)
Pin Color and functions of Connector A, B, C and D
A1 Orange/White
A2 Yellow
A4 Red
A5 Blue
A6 Black
White ª / White/Black ·
A8/A7
A10/A9 Gray ª / Gray/Black ·
Green ª / Green/Black ·
B2/B1
Purple ª / Purple/Black · Right speaker (rear)
B6/B5
C5 Blue
D21 Light green/Red
D22 Purple/Red
D23 Gray/Red
Connect to the vehicle's steering remote
harness.
• Depending on the type of vehicle, it cannot
D22
D23
be connected.
Connect to the vehicle's reverse lamp harness when
using the optional rear view camera.
Connect to the vehicle's parking
brake detection switch harness.
3
• For best safety, be sure to
connect the parking sensor.
Dimmer
Battery
Ignition (ACC)
Antenna control
Ground connection
Left speaker (front)
Right speaker (front)
Left speaker (rear)
Antenna control
Input 1
Input 2
Ground
ENGLISH 69