How To Reset Your Unit - Kenwood DDX7015BT Instruction Manual

Monitor with dvd receiver

Hide thumbs Also See for DDX7015BT:

Instruction manual (76 pages)

Instruction manual (80 pages)

Table Of Contents

Table of Contents

BEFORE USE

For DDX5902:

CAUTION

Use of controls or adjustments or performance of

procedures other than those specified herein may result in

hazardous radiation exposure. In compliance with Federal

Regulations, the following are reproductions of labels on,

or inside the product relating to laser product safety.

JVC KENWOOD Corporation

2967-3, ISHIKAWA-MACHI, HACHIOJI-SHI, TOKYO, JAPAN

THIS PRODUCT COMPLIES WITH DHHS RULES 21CFR

SUBCHAPTER J IN EFFECT AT DATE OF MANUFACTURE.

Location : Top plate

FCC WARNING

This equipment may generate or use radio frequency

energy. Changes or modifications to this equipment may

cause harmful interference unless the modifications are

expressly approved in the instruction manual. The user

could lose the authority to operate this equipment if an

unauthorized change or modification is made.

FCC NOTE

This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful

interference in a residential installation.

This equipment may cause harmful interference to

radio communications, if it is not installed and used in

accordance with the instructions. However, there is no

guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful

interference to radio or television reception, which can

be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference

by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and

receiver.

• Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV

technician for help.

For DDX5902:

IC (Industry Canada) Notice

This device complies with Industry Canada license-

exempt RSS standard(s).

Operation is subject to the following two conditions:

(1) This device may not cause interference, and (2) this

device must accept any interference, including interference

that may cause undesired operation of the device.

The term "IC: " before the certification/registration

number only signifies that the Industry Canada

technical specification were met.

CAUTION

This equipment complies with FCC/IC radiation exposure

limits set forth for an uncontrolled environment and

meets the FCC radio frequency (RF) Exposure Guidelines

in Supplement C to OET65 and RSS-102 of the IC radio

frequency (RF) Exposure rules. This equipment has very

low levels of RF energy that it deemed to comply without

maximum permissive exposure evaluation (MPE). But it is

desirable that it should be installed and operated keeping

the radiator at least 20 cm or more away from person's

body (excluding extremities: hands, wrists, feet and ankles).

Under Industry Canada regulations, this radio

transmitter may only operate using an antenna of a

type and maximum (or lesser) gain approved for the

transmitter by Industry Canada. To reduce potential

radio interference to other users, the antenna type

and its gain should be so chosen that the equivalent

isotropically radiated power (e.i.r.p.) is not more than

that necessary for successful communication.

• Contains Transmitter Module

FCC ID : YZP-RBFAC21XX

• Contains Transmitter Module

IC: 7414A-RBFAC21XX

Cautions on the monitor:

• The monitor built into this unit has been

produced with high precision, but it may have

some ineffective dots. This is inevitable and is not

considered defective.

• Do not expose the monitor to direct sunlight.

• Do not operate the touch panel using a ball-point

pen or similar tool with a sharp tip.

Touch the buttons on the touch panel with your

finger directly (if you are wearing a glove, take it

off).

• When the temperature is very cold or very hot...

– Chemical changes occur inside, causing

malfunction.

– Pictures may not appear clearly or may move

slowly. Pictures may not be synchronized with

the sound or picture quality may decline in such

environments.

For safety...

• Do not raise the volume level too much, as this

will make driving dangerous by blocking outside

sounds, and may cause hearing loss.

• Stop the car before performing any complicated

operations.

Temperature inside the car...

If you have parked the car for a long time in hot or

cold weather, wait until the temperature in the car

becomes normal before operating the unit.