Advertisement
All program settings are protected by a Master Code, to prevent unauthorized changes.
When setting up the 917 keypad for the first time (or if the Master Code has been lost) the first step is to program the
Master Code you'd like to use.
Master Code, Initial Setup:
1) Disconnect power from the keypad.
2) Set the DAP jumper to "ON"
3) Connect power to the keypad. The keypad should start beeping continuously, and the yellow LED
flashing continuously.
4) Move the DAP jumper to "OFF". The keypad should stop beeping, and the yellow LED lit steady.
0 MMMM #
5) Enter:
use.
Example: 0 1234 #
Other Programming:
Description
(1) Set User Code
(1) Delete User Code
(40) Set Relay Time
(41) Set Relay to Latch
(0) Change Master Code
(8901) Reset All Settings to
Factory Defaults
(Not incl. Master Code)
Programming Pattern: As you can see, all programming entries follow the same pattern:
[Master Code
[Master Code
keypad's yellow LED being lit steady.
[Number] tells the keypad which feature to change. 0=Master Code; 1=User Code; etc.
[#
] completes the programming sequence.
Note: All of the programming examples use a Master Code of "1234" but that's not advisable in actual practice,
because it's too easy for unauthorized personnel to guess.
P:\INSTALLATION INST\ACCESS CONTRLS\INST-917 Stand Alone.vsd
Programming
into the keypad, where "MMMM" is the four-digit Master Code you'd like to
would set the Master Code to "1234"
Keypad Entry
MMMM
1 DD UUUU #
MMMM = Master Code
DD = User ID Number, 01-99
UUUU = User Code, 4-8 digits
MMMM
1 DD #
MMMM = Master Code
DD = User ID Number, 01-99
MMMM
40 TT #
MMMM = Master Code
TT = Relay Time, 01-999 seconds
MMMM
41 #
MMMM = Master Code
MMMM
0 MMMM #
MMMM = Master Code
MMMM = New Master Code
MMMM
8901 #
MMMM = Master Code
] + [number] +
[information to enter, if
] sets the keypad into programming mode. Programming mode is identified by the
Rev G
any] +
[#
03-10
Page 3
Example
1234
1 47 7890 #
Using a Master Code of "1234"
set User ID "47"
to a User Code of "7890"
1234
1 21 #
Using a Master Code of "1234"
delete the User Code
for User ID "21"
1234
40 05 #
Using a Master Code of "1234"
set the Relay Time to 5 seconds
1234
41 #
Using a Master Code of "1234"
Set the relay to toggle (on/off)
mode.
1234
0 4321 #
Change the Master Code from
"1234" to "4321"
1234
8901 #
Using a Master Code of "1234"
Reset all settings to the factory
defaults.
]
Advertisement
