Univex T50 Operator's Manual page 8

THICKNESS
REGULATION
CONTROL ARM
RELEASE BUTTON
Thickness Regulation - This control determines the spacing between the rollers. The thickness of the
Control Arm
Thickness Level - These stops are used as guides to set the Thickness Regualtion Control Arm for a
Stops
Release Button - This releases the Thickness Regulation Control Arm so it can be moved back to
OPERATION
To regulate the thickness of the pastry rolling use the lever according to the following indications
2
dough should be achieved through gradual movement of this control. Trying to
achieve to thin of a pass abrubtly, will jam the machine and not produce the desired
results.
start and stop point for the desired thickness level.
open the roller spacing.
1
Rotate the lever to set the sheeting
thickness
THICKNESS LEVEL
STOPS
Maximum and
minimum opening
can be regulated
Press button (1) and
by holding it pressed
rotate the lever (2),
to regulate the
2
sheeting within the
maximum and
minimum points
established. Release
the button
8 of 11