DCS RF24TR Installation, Operation And Maintenance Instructions page 18

Figure 39
Soak up water
from plastic
drain pan if
necessary
Figure 40
Remove the power
cord from the grommet
in the access cover.
CARE AND CLEANING
17. Leave door open and allow to completely dry out be-
18. Thoroughly clean the door gasket with anti-bacterial
19. Thoroughly clean the exterior with a cleaner approved
20. Any mounting hardware / fasteners that are showing
21. Once the exterior has been thoroughly cleaned, you
Remove 11
screws from
around the
perimeter of the
After completion of the above, you may choose to store the
access cover
unit indoors, although this is not required.
with a ⁄ " nut
5
16
driver.
Start-Up After Long-Term Storage:
1. Connect the unit to electrical power.
2. If stored outside, it is recommended that the unit again
3. Turn unit on and confirm your desired control settings.
4. Allow 24-hrs for the unit to stabilize before loading
Clean out
debris
18
fore closing door.
cleaner to be followed with clean rinse water to remove
any residual chemicals.
for stainless steel . Do not use any abrasive cleaners
or scouring pads.
signs of corrosion should be replaced.
may want to apply a coating of car wax to help protect
against spotting from moisture, dirt, and debris that
may accumulate on the surfaces during the Winteriza-
tion period.
be thoroughly inspected per the storage instructions
above to address any dirt or debris from the weather
and/or animals/insects.
contents.