DCS RF24TR Installation, Operation And Maintenance Instructions page 13

8. Locate the CO tank in the corner of the refrigerator as
2
shown in Figure 26 and secure with the chain. Close
the faucet handle on the tower.
9. Hooking up the keg coupler to the keg: Verify the cou-
pler is in the "OFF" position (see Figure 27a).Align the
lugs on the keg with the corresponding openings on the
keg coupler and turn clockwise until the coupler stops
(about 90°). Push down and twist the top of the coupler
clockwise to allow gas to enter the keg.
Figure 26
Lugs
on keg
Figure 27b
USING YOUR BEER DISPENSER
Push faucet handle back toward
tower to close the faucet
Chain-The chain is fastened and taped
to the top of the interior liner. Remove
the tape and secure the CO
place in the back right corner.
tank in
2
Rotate the top of the coupler coun-
ter clockwise to extend the coupler
to the to the "OFF"position.
Figure 27a
Figure 27
13
Coupler
extended