DCS RF24TR Installation, Operation And Maintenance Instructions page 12

Rear of counter top
1
(3.5 cm)
typical
Diameter
to suit
counter
top depth
25 ⁄ "
5
16
(64.3 cm)
Figure 23
CAUTION
!
The cutout dimensions shown in Figure 23 are based on
a 25 ⁄ " (64.3 cm) deep counter top. Your counter top may
5
16
be different than this and require other front to back dimen-
sioning. Refer to the product dimensions on page 8 when
determining the required dimensions.
Figure 24
USING YOUR BEER DISPENSER
⁄ "
3
8
1 ⁄ (38 mm)
1
2
Diameter
2 ⁄ "
7
8
(7.3 cm)
Tower
4. If you are installing your keg refrigerator under a
counter you will need to drill 5 holes in the counter top
to mount the tower. The first hole is a 1
hole located at the center of the tower for the beer line,
locate approximately 13
edge of the counter top (based on a counter top depth
of 25 ⁄ "). Next drill the 4 tower mounting holes per the
5
16
dimensions in Figure 23. The hole diameter is depen-
dent on the counter top material and if screw anchors
are required. The screws supplied are in the literature
pack and are a #10 x 1" type AB stainless steel screw.
After the holes are drilled and the keg refrigerator is in
place under the counter top feed the beer line through
the tower gasket, the 1
the hole in the top of the keg refrigerator. Mount the
tower to the counter top with the 4 screws provided.
5. Mount the regulator to the CO
use the new plastic washer you received from the gas
supply company. Note that the regulator has left hand
threads and has to be turned counterclockwise to
tighten. Tighten with the adjustable wrench or the 1
open end wrench.
6. Connect the red air line(s) from the regulator to the
large air line fitting on the keg coupler with a large
hose clamp (connection
7. Connect the clear beer line from the tower to the small
air line fitting on the keg coupler with a small hose
clamp (connection
12
⁄ " diameter
1
2
⁄ " (34.3 cm) from the front
1
2
⁄ " hole in the counter top and
1
2
tank (connection
2
).
C
).
A
Figure 25
)
B
⁄ "
1
8