Sony CDP-CX70ES Service Manual page 23

SENSOR ALIGNMENT
Perform this adjustment after the "holder (disc A2) adjustment".
If the disc table swings to the left and right just before the disc is
chucked, perform the following adjustment.
Gam
Cam
LEVER (stopper)
assembly
(1) Rotate the cam and adjust to the position
shown in the figure.
Bracket (sensor)
(2) Check that the lever (stopper) assem-
bly secures the disc table as shown in
the figure.
Lever c stopper) assembly
Lummus board
Fixed screw
Table assembly
(4) Moving the disc table right and left with a hand after the screw
is fixed, the table will move by the play of a disc table. If the
LEDs light up alternately, the adjustment will be performed cor-
rectly.
PLAY bUtton
PAUSE button
(3) Loosen the fixed screw by 60° to 90°, and use a tapering screwdriver to adjust the screw as shown in the figure.
Move the bracket (sensor) with the tapering screwdriver little by little, and fix the fixed screw at where the play button's LED (green) Js
switched to the pause button's LED (orange) (or its reverse).
-23-