Troubleshooting - MABIS 04-255-001 Manual Book

If any abnormality occurs during use, please check and
correct the following:
CONDITION
Display is blank
when power is on.
Measurement incomplete
or abnormally low or high
values displayed.
"Error" displays.
The display reads
"TEST MODE."
The Power turns off
when the POWER
button is pressed.
Measurements are different
from those typically measured
by physician or every
measurement reading is
different.

TROUBLESHOOTING

CORRECTION
Check the polarity of the batteries.
Reinstall or replace batteries.
Clean the battery compartment
with a dry cloth.
Review and follow "Applying Your
Blood Pressure Cuff" and "Taking
Your Blood Pressure Reading"
sections. Is your posture is correct?
Is the cuff wrapped correctly? Are
you quiet during measurement?
Turn power off and take another
measurement. Remain quiet, do
not move during measurement.
Is the cuff too loose, too tight, in
the correct position? Review and
follow "Applying Your Blood
Pressure Cuff" and "Taking Your
Blood Pressure Reading" sections.
If the POWER button is held down
too long (approximately 2 seconds),
press the POWER button again
to restart the measurement.
If the POWER button is held down
too long (approximately 2 seconds),
press the POWER button again
to restart the measurement.
Remember, blood pressure
readings are influenced by
physical and mental conditions
and/or even the time of day.
Daily measurements should be
interpreted by your physician.
23