MABIS 04-255-001 Manual Book page 15

1) Press MENU to enter Feature list
2) Scroll (+/-) to "Preset Pressure"
3) Press MENU button
4) Use (+/-) keys to increase or decrease the pressure in
increments of 10. The pressure should be 30mmHg higher
than your known Systolic pressure.
5) Press POWER to turn off.
The available range is 150 - 300 mmHg.
MEMORY CLEAR
This feature will only display after measured
data has been stored (see Memory Select).
Stored readings can be deleted from each
memory bank.
Choose the Memory Bank 1 or 2:
1) Press MENU to enter Feature list
2) Press MENU button for "Memory Select"
3) Scroll (+/-) to select either M1 or M2
4) Press POWER to turn off
NOTE! Pressing Power will allow you to exit
"Memory Clear" without deleting any readings.
Memory Clear:
5) Re-enter Feature list by pressing MENU
6) Scroll (+/-) to "Memory Clear" and press MENU
7) Use (+/-) keys to move the cursor in front of the reading
to be deleted.
8) Press MENU to delete. The numbering sequence will
reflect the change.
Repeat as needed.
9) Press POWER to turn off or to exit.
13