mabe JGBP86 Owner's Manual & Installation Instructions page 56

Before you call for service...
Troubleshooting Tips
Problem
Excessive smoking
Oven door will not open
after a clean cycle
Oven not clean after a
clean cycle
"Door" appears in the
display (on models
with a door latch)
"LOCK DOOR" flashes
in the display
LOCKED DOOR light
is on when you want
to cook
"F—and a number or
letter" flash in the display
Oven shelves are
difficult to slide
"Probe" appears in
the display (some models)
56
Possible Causes
Excessive soil.
Oven too hot.
Oven controls not properly set.
Oven was heavily soiled.
Latch handle was moved to the
right but a program other than
self-clean was selected.
The self-clean cycle has been
selected but the door is not
closed and on models with a latch,
the latch was not moved all the
way to the right.
The oven door is locked
because the temperature
inside the oven has not
dropped below the
locking temperature.
On models with a door latch,
if a function error code appears
during the self-cleaning cycle,
check the oven door latch.
You have a function error code.
If the function code repeats.
The nickel shelves (if so equipped) • Apply a small amount of vegetable oil to a paper
were cleaned in a self-clean cycle.
The gray porcelain-coated shelves
(if so equipped) were improperly
cleaned.
This is reminding you to enter a
probe temperature after plugging
in the probe.
What To Do
• Touch the CLEAR/OFF pad. Open the windows to
rid the room of smoke. Wait until the LOCKED DOOR
light goes off. Wipe up the excess soil and reset the
clean cycle.
• Allow the oven to cool below locking temperature.
Do not lock the door with the door latch except when
using the self-clean feature.
• See the Using the self-cleaning upper oven section.
• Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
• Move the latch handle to the right only when setting
the self-cleaning cycle.
• Close the oven door and on models with a latch, move
the latch all the way to the right.
• Touch the CLEAR/OFF pad. Allow the oven to cool
and then, on models with a door latch, unlock the door.
• The latch may have been moved, even if only slightly,
from the locked position. Make sure the latch is moved
to the right as far as it will go.
• Touch the CLEAR/OFF pad. Allow the oven to cool for
one hour. Put the oven back into operation.
• Disconnect all power to the range for 5 minutes
and then reconnect power. If the function error
code repeats, call for service.
towel and wipe the edges of the oven shelves with
the paper towel. Do not spray with Pam
lubricant sprays.
• Enter a probe temperature.
® or other