Volvo V 70 Owner's Manual page 325

the foam block. The foam block contains all
the tools needed to change the wheels.
Taking out the spare wheel under the
cargo area floor
1. Fold up the cargo area floor, from the rear
and forwards.
2. Undo the retaining screw.
3. Lift out the foam block with its tools.
4. Lift out the spare wheel.
Removing
Set up warning triangle (p. 326) if a wheel is
replaced in trafficked location. The car and
jack* must be on a firm horizontal surface.
1. Apply the parking brake, (p. 292) and
engage reverse gear, or position P if the
car has an automatic gearbox.
WARNING
Check that the jack is not damaged, that
the threads are thoroughly lubricated and
that it is free from dirt.
NOTE
Volvo recommends only using the jack*
that belongs to the car model in question,
which is indicated on the jack's label.
The label also indicates the jack's maxi-
mum lift capacity at a specified minimum
lifting height.
2. Take out jack*, wheel wrench*, removal
tool for wheel covers* and for the wheel
bolts' plastic caps that are fitted in the
foam block. If another jack is selected,
see Raising the car (p. 351).
Tool for removing the plastic caps on the wheel
bolts.
09 Wheels and tyres
3. Place chocks in front of and behind the
wheels which will remain on the ground to
prevent them from rolling. Use heavy
wooden blocks or large stones for exam-
ple.
4. Cars with steel rims have removable
wheel covers. Use the removal tool to
hook in and pull off any full-wheel wheel
covers. Alternatively, the wheel covers
can be pulled away by hand.
*
Option/accessory, for more information, see Introduction.
09
}}
323