Advertisement
One Antenna
must mount
here and point
upwards.
Figure 6 - Connecting Antennas
NOTE: The remaining Antenna Connector and the remaining holes
in the used Antenna Connectors are not used.
4.0
Wiring and Power Up
4.1 Wiring the Receiver to the Control Panel
• Disconnect power from the Control Panel.
• Connect the Receiver Terminals to the Control Panel Terminals
as shown in Figure 7 using 0.8 mm diameter or larger wire. Wire
length between the Receiver and the Control Panel should not
exceed 300 meters.
• Replace the Outer Cover.
EDM Panel
Figure 7 - Connecting to the EDM Panel
Do not connect the RF3212E to the Keypad Bus on
the EDM Panel.
• Apply power to the Control Panel. The red LED at the center of
the Receiver should light.
4.2 LED Status
The following describes the status of the Receiver based on the
LED condition.
LED on -
The Receiver is functioning normally.
LED off -
A power failure has occurred or the Receiver is
not wired correctly.
LED flashes - The Receiver acknowledged receiving an RF
signal from a compatible RF transmitter.
© 2004 Bosch Security Systems
130 Perinton Parkway, Fairport, New York, USA 14450-9199
Customer Service: (800) 289-0096; Technical Support: (888) 886-6189
5.0
Use one
For programming information, refer to the following Control Panel
of these
locations
Reference Guides:
for the
Solution Ultima 844 Quick Reference Guide MA844Q
second
Solution Ultima 862 Quick Reference Guide MA862Q
Antenna
Solution Ultima 880 Quick Reference Guide MA880Q
Preferred
Location
(provides polar
diversity)
RF3212E
PWR
- DATA
+
Panel Programming
03/04
RF3212E Installation Instructions
P/N: 42785E
Page 2
Advertisement
