Electrolux EI24ID50Q Use And Care Manual page 7

E n e r g y O p t i o n S e l e c t i o n s
Hi-Temp
When HI-TEMP option is selected, the dishwasher
heats water in the main wash to approximately
0 0
140 F (60 C).
This increase in water temperature helps
dishwasher detergent remove food, grease and soil
from dishes more effectively and aids in drying. HI-
TEMP option can only be used with AUTO, HEAVY,
NORMAL and UPPER cycles.
Sanitize
To sanitize your dishes and glassware, select the
SANITIZE option. This option heats the water
temperature in the fi nal rinse to 157
and maintains that temperature for 7 minutes.
SANITIZE is available in Auto, Heavy, and Normal
cycles. Only these sanitization cycles have been
designed to meet NSF requirements.
The cycle time will be extended until the proper
water temperature is reached. Washing action will
continue during the water heating delay. For best
results, the incoming water temperature should be
at least 120 0 F (49 0 C).
If the SANITIZE option is selected, the led above
the pad comes on. The sanitization criteria may
not be satisfi ed if there is an interruption of the
cycle, a power failure occurs, or if incoming water
temperature is below 120
Sanitize led fl ashes at the end of the cycle if the
NSF requirements for sanitization are not reached.
Child Lock Controls/Air Dry
To prevent children from accidentally changing
the dishwasher cycle or starting the dishwasher,
lock the dishwasher controls by pressing the AIR
DRY pad until "Loc" shows in the status window.
The controls are locked and no new selections
can be made until the lock is released. To unlock
the controls, press the AIR DRY pad until "Loc"
disappears.
Operating Instructions
0 F (69.4 0 C)
0 F (49 0 C).
Max Dry
MAX DRY is available on Auto, Heavy, Normal,
Upper and Stemware cycles The cycle time will
increase when MAX DRY option is selected.
O p e r a t i o n S e l e c t i o n
Delay
The Delay Start option allows you to automatically
delay starting your dishwasher from 1 to 24 hours.
Press DELAY pad until the desired delay time
shows in the Status window then press START to
activate. Display will indicate the delay start time
and will countdown until cycle starts.
To cancel the DELAY option and begin the cycle
before the delay period is over, press the CANCEL
pad and then the START pad.
Start
To start a cycle, press the START pad once and
close the door.
Cancel
To cancel a cycle at anytime, open the door and
press the CANCEL pad until you hear a tone.
When the door is opened, the last cycle selected
will be displayed. If desired, a new cycle can now
be selected by pressing CANCEL pad and upon
closing the door the cycle will begin.
NOTE
Opening the door during normal operation will
only pause the selected cycle.
7