Sony HVL-F32M Operating Instructions Manual page 34

• Confirm that the flash unit that is attached to the camera is set as
the controller. For details, refer to the operating instructions of
the flash unit.
5
Position the camera and this flash unit. (page 29)
6
Confirm that the built-in flash or the flash unit that is
attached to the camera, and this flash unit are fully
charged.
When the charge progress indicator lights in green, this flash unit is
ready to fire. Also, the flash-ready indicator that is located on the
front side of this flash unit blinks in the wireless-flash mode.
7
Press the shutter button to take a photo.
• For the test-flash, refer to the operation instructions of your
camera.
• If this flash unit does not fire, change the position of the camera,
this flash unit or subject, or point the wireless control-signal
receiver towards the camera.
• The built-in flash of the A-mount camera, or the HVL-F20M, HVL-
F32M, HVL-F43M or HVL-F60M can be used as the controller.
34
GB