Table of Contents
Advertisement
TO REPLACE WITH A NEW BATTERY:
1. Remove the battery compartment cover
as per illustration on the right.
2. Observing the correct polarity and put a
3Vdc lithium battery (CR2025, not
included).
3. Close the cover.
Precautions concerning batteries
Be sure to insert batteries with correct polarities.
Rechargeable and non‐re‐chargeable batteries can be used. Refer to the
precautions on their labels.
When the remote control unit is not to be used for a long time (more than a
month), remove the batteries from the remote control unit to prevent them
from leaking. If they leak, wipe away the liquid inside the battery
compartment and replace the dead batteries with new ones.
Do not heat or disassemble batteries and never dispose of old batteries by
throwing them in a fire.
SETUPS/CONNECTIONS
ASSEMBLY
Remove all packing materials and disposal of them properly.
LOCATE THE WIRE ANTENNA
Unwind the wire antenna and extend it to full length, locate the wire antenna
to get best reception.
AC OPERATION
You can power the radio with the supplied AC adapter. Check the rating plate on
the AC adapter with your mains power voltage before powering the radio on.
The AC adapter is 100‐240V~50/60Hz input, 12V
internal pole.
Place the unit on a stable surface away from heat and damp.
Extend the FM antenna fully.
Uncoil the power cable fully.
Plug the AC adapter plug into the wall socket and switch the mains power
on.
Your unit is ready for use.
2A output, with positive
8
Advertisement
Table of Contents
