TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS BEFORE USE LOCATION OF CONTROLS REMOTE CONTROL REMOTE CONTROL UNIT BATTERY INSTALLATION SETUPS/CONNECTIONS ASSEMBLY LOCATE THE WIRE ANTENNA AC OPERATION BASIC OPERATION LISTENING TO A RADIO STATION TO LISTEN TO THE STORED STATION BLUETOOTH FUNCTION PLAYING AN EXTERNAL AUDIO SOURCE TROUBLESHOOTING GUIDE SPECIFICATIONS 2 ...
IMPORTANT SAFETY INSTRUCTIONS Please read this user manual carefully before you use this product. Please reserve it properly for reference in the future. Please do not expose the unit in the raining or moist environment to avoid fire hazard or electric shock. On the machine should not receive the water drop or the water splashes, on the machine could not lay object filled with liquid, like vase. THE AC MUST REMAIN EASILY ACCESSIBLE IN ORDER TO BE ABLE TO DISCONNECT THE DEVICE IN CASE OF EMERGENCY. 1. Read through the manual before operating. 2. Heed the instructions. 3. Follow all instructions in the manual. 4. Keep the manual for future reference. 5.
Page 4
where they exist from the apparatus. 13. This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your product dealer or local power company. For products intended to operate from battery power, or other sources, refer to the operation instructions. 14. The mains plug is used as disconnect device. The mains plug of apparatus should not be obstructed OR should be easily accessed during intended use. To be completely disconnect the power input, the mains plug of apparatus should be disconnected from the mains. 15. An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal. 16. If the apparatus is not used for a period of time, unplug the power cord. 17. If the remote control unit is not used for a period of time, remove batteries from the remote control unit and store them in a cool dry area. 18. If it is lightening, unplug the power cord to prevent the unit from unnecessary damages. 19. This product should be moved with care to avoid damage or injury. 20. Never try to disassemble batteries. Neither put batteries under the direct sunlight nor throw them into fire or heater. As all of these may cause unnecessary damages to you. 21. Refer all servicing to qualified service personnel. Servicing required when the apparatus does not operate normally or has been damaged in any way such as the power cord or plug is damaged, liquids spilled into the apparatus, any hard object fallen on the apparatus, the apparatus has ...
3. This product must be connected to an electrical supply 100‐240V ~ 50/60Hz. 4. The plus must be accessible after installation. 5. Hold the plug well when you plug the power cord in or out. 6. Please do not put the AC power cord near any heat source equipment. 7. Please do not place any heavy objects on the AC power cord. 8. Please do not overhaul the AC power cord. 9. This product contains a low power laser device. In order to keep safety, please do not open the unit to expose the inside parts. If there is some problem need to be repaired, please let the professional people check and repair it. CAUTION 1. Use of controls and adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. 2. If this product develops trouble, contact qualified service centers, and do not ...
REMOTE CONTROL (STANDBY): Press and hold to 1 turn the unit on or set it to standby. FUNC.: Select a source. : Use to play or pause. 3 In FM mode, press to auto search and store stations. /: Use these buttons to skip tracks. 4&5 In FM mode, use these buttons to search stations. VOL+/VOL‐: Use these buttons to adjust the volume. 6&7 REMOTE CONTROL UNIT You may operate the apparatus in a distance with the remote control. Within the effective range, point the remote control towards the front panel of the apparatus. BATTERY INSTALLATION TO ACTIVATE THE REMOTE CONTROL: The remote control is built with cell battery before shipment. To activate the battery, remove the transparent plate at the bottom of the remote control. Now the remote control is ready to use. BATTERY REPLACEMENT: If the distance required between the remote control unit and main unit decreases, the battery is exhausted. In this case, please replace the battery with new one. ...
TO REPLACE WITH A NEW BATTERY: 1. Remove the battery compartment cover as per illustration on the right. 2. Observing the correct polarity and put a 3Vdc lithium battery (CR2025, not included). 3. Close the cover. Precautions concerning batteries Be sure to insert batteries with correct polarities. Rechargeable and non‐re‐chargeable batteries can be used. Refer to the precautions on their labels. When the remote control unit is not to be used for a long time (more than a month), remove the batteries from the remote control unit to prevent them from leaking. If they leak, wipe away the liquid inside the battery compartment and replace the dead batteries with new ones. Do not heat or disassemble batteries and never dispose of old batteries by throwing them in a fire. SETUPS/CONNECTIONS ASSEMBLY Remove all packing materials and disposal of them properly. LOCATE THE WIRE ANTENNA Unwind the wire antenna and extend it to full length, locate the wire antenna to get best reception. AC OPERATION You can power the radio with the supplied AC adapter. Check the rating plate on the AC adapter with your mains power voltage before powering the radio on. The AC adapter is 100‐240V~50/60Hz input, 12V ...
BASIC OPERATION 1. Press and hold the / button to turn the unit ON. 2. Press the FUNCTION button repeatedly to select a desired mode (FM, AUX ‐IN or BLUETOOTH). 3. Press the VOLUME+ and/or Volume ‐ button to adjust the volume. 4. Press the / button to select the track. Now the unit is ready to use. To set the unit into STANDBY Press and hold the / button. Or, press the (STANDBY) on the remote control. To disconnect the power completely Disconnect the AC acdaptor from the working electric outlet especially when the unit is not in user for an extended period. LISTENING TO A RADIO STATION 1. Press the FUNCTION button repeatedly to select the FM ( ) mode. 2. Search a station. To auto search and store stations Press the / button, the unit will auto search stations and save them into the unit’s memory. ...
PLAYING AN EXTERNAL AUDIO SOURCE An external (auxiliary) audio source (i.e., personal CD player or MP3 player) can be connected to this unit. The unit has 2 AUX INs at the back of the unit. 1. Plug one end of the AUX IN cable (included) into the AUX IN sockets at rear of the unit. For AUX‐IN 2, always make sure the white plug is connected to the white socket and the red plug in the red socket. 2. Plug the other end of the cable into the headphone or Line Out socket of the external source. 3. Press the FUNCTION button repeatedly to select a respective AUX mode ( ) that you have connected. 4. Turn on the external audio source and adjust volume level. 5. Set the external audio source to normal play. TROUBLESHOOTING GUIDE If you have any trouble with the unit, please look through this chart and see if you can solve the problem yourself before calling your dealer. Problem Cause Solution Power does not come Connect the unit to the AC on when the unit is Unit is unplugged. power supply. switched on. The volume is turned down (to Adjust the volume. No sound comes out of MIN). Re‐select the desired input the speakers. The input selector source. does not match the ...
Remove the power cord from the AC outlet and The unit does not act The unit needs to disconnect all power supply as expected. reboot. devices. After one minute re‐plug the power cord. The station is not tuned in properly. Properly tune in the desired Can’t listen to any A TV set is being station. station, or signal used nearby and is Turn off the interfering TV appears weak. interfering with the set. radio reception. Re‐position the antenna The antenna is not The sound is distorted. until the reception oriented properly. improves. Can’t play the device The device is not or the device cannot Re‐dock the device. properly docked. be detected. SPECIFICATIONS Output Power …………. 2 X 30WATTS + 2 X 10WATTS Frequency Response …………. 60 to 20,000Hz Input Power ...
Page 12
DETAILS AND PRECAUTIONS ON THE USE OF BATTERIES ‐ Discard a used battery in nature or garbage pollutes and prevents the recovery of recyclable materials. It is therefore important to limit consumption of batteries and follow these guidelines: ・ focus on alkaline batteries (that last longer than the saline batteries) and when possible, rechargeable batteries ・ deposit batteries and accumulators in specific containers arranged among traders. For example, metals will be valued and polluted the environment because they contain heavy metals hazardous to health and the environment primarily (cadmium and nickel) ‐ The piles must installation by respecting the polarity indicated on the apparatus and the pile. An incorrect positioning can is to damage the apparatus, is to cause escapes on the level of the pile, is to the extreme to cause a fire or the explosion of the pile. ‐ To ensure proper operation, the batteries must be in good condition. In case of abnormality in the functioning of the device, put fresh batteries ‐ Never attempt to recharge non‐rechargeable batteries. They could run, warm up, causing a fire or explosion. ‐ Replace all batteries at the same time. Never mix zinc batteries with alkaline batteries or rechargeable batteries ‐ The batteries must be removed from the device ‐ Also, remove the batteries from your device if you do not use it for a long time, if the batteries may leak and cause damage. ‐ Never try to short‐circuit the battery terminals ‐ Never dispose of batteries in fire, they might explode ...
Page 13
replacement of batteries. ‐ If a battery is swallowed, immediately consult a doctor or poison control center nearest you. Do not forget to carry the product with you. We certify that the power supply is used as a device for disconnecting the power distribution network, which should stay easily accessible. “Declaration of conformity available on simple request” 13 ...