Table of Contents
Advertisement
Available languages
Available languages
Major operations and their functions (continued)
Rear View
1
ON
MAIN
OFF
~
AC IN
5
1. MAIN switch
This is the main power switch. When using this unit,
set this switch to ON. Otherwise, the power cannot
be turned on/off using the POWER button on the front
of the unit.
2. VIDEO OUT connectors
VIDEO OUT connector
Output connector for video signal to monitor (BNC
connector).
S(Y/C) OUT connector
These are output connectors for video signals that
separate brightness signals and color signals for
higher picture quality. Simultaneous output along with
VIDEO OUT is also possible.
3. CAMERA IN connectors
Input connector for signal of camera (BNC connector).
4. CAMERA OUT connectors
Camera video output connectors for use of BNC con-
nectors. If the MAIN switch is ON, the through out-
put is possible for the camera image inputted into
each CAMERA IN connector.
5. AC power socket
This socket connects to the power cord. Earth ter-
minal is for safety. Use the 100 ~ 240V plug with
earth for the power of this unit.
If there is no ground terminal on the wall outlet,
contact your dealer of purchase for grounding work
(with charge). When there is no ground terminal in a
wall socket, please request ground construction from
a store. (It is a charge.) Do not connect the earth
terminal of a plug to gas pipe, water pipe, lightning
rod and so on.
•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
4
2
3
1
2
Y/C
1
2
VIDEO OUT
RESET
RESET
OUT
AUDIO
IN
MIC
GND
6
7
8
9
6. AUDIO connectors
7. GND terminals
8. MIC jack
9. RESET button
10. ALARM IN terminals
11. I/O terminals
3
4
CAMERA IN
5
6
CAMERA OUT
3
4
5
6
ALARM IN
10
11
12
AUDIO IN connector
Input connector for audio signal (RCA pin).
AUDIO OUT connector
Output connector for audio signal (RCA pin).
It is the common GND terminal.
Input connector for microphone (600 ohm imped-
ance). MIC jack is preferentially inputted to the AU-
DIO IN connector.
Pressing this button resets the unit and the power
turns off. In this case, video data, menu settings and
the current time are kept.
Input terminal for alarm signal.
CLOCK ADJ terminal
Input terminal to set the present time. Time display
is adjusted to the nearest hour (00 minutes 00 sec-
onds) when this terminal receives the CLOCK ADJ
signal.
INFORMATION
The on-screen clock can be reset to the nearest hour,
by applying a signal to the CLOCK ADJ terminal. For
example, if the current time is 11:29:59, it will be reset
to 11:00:00, and if the current time is 11:30:00, it will be
reset to 12:00:00.
4
7
8
9
7
8
9
RS-232C
RS-232C
Advertisement
Table of Contents
