Manual Dialing Transmission - Sanyo SFX-33 Instruction Manual

Manual dialing transmission
1. Place the original document face down.
Adjust the paper guide to the width of
the document.
2. Select a contrast/resolution mode if
necessary. (See page 19.)
3. Lift the handset and dial the number.
Example: 123456.
4. When the line is connected, transmission
begins automatically.
5. Replace the handset.
\ STD NORMAL
I
STD NORMAL
123456
DEALER A
Press [STOP/C] to interrupt a transmission or to remove a document set for transmission.
If you make a mistake when entering a phone number, replace the handset then lift it again
and enter the correct number.
The feature switch No. 54 must be set to the ON (01) position for automatic transmission to
take place at step 4. (Default position of factory setting is,ON.)
If it is set to the OFF (00) position, the [START key has to be pressed to initiate transmission.
(See page 49-50.)
Transmission report
When a fax transmission is completed, the SFX-33 can print out a transmission report showing
the other party's name or phone number, the number of the transmitted originals and the
transmission result.
The automatic transmission report printout has been factory-set to the OFF (non-issue)
position. To change the setting to ON (after each transmission) or ON (when an error occurs),
use the feature switch No. 31. (See page 49-50.)
21