Wiring - Jensen DV352 Owner's Manual

DV352

Wiring

Power Connections
1. GROUND WIRE (black) – Securely fasten the Ground wire to a grounded metal part of the
car's chassis. If you cannot find an existing bolt or screw to fasten it to, drill a hole in the metal
and secure it with a screw. To ensure a good ground, remove any paint or grease from areas
where the wire will contact the surface.
2. CONSTANT POWER WIRE (yellow) – Connect the 12V PLUS constant power wire to a live
12 volt wire in the vehicle. Before making a connection, check that the wire you intend to
connect it to is always live, even when the car's ignition is turned off. If a live wire is not found,
route the wire to the car's fuse block and connect it to a live circuit there.
3. ACC POWER WIRE (red) – Connect to a +12 volt circuit that is only live when the ignition is
on. The best connection point is at the car's fuse block at the "RADIO" or "ACCESSORY"
identified terminals.
VIDEO 1 AUDIO INPUT 1
INPUT
L R
DC12VIN DC12VOUT
+
Black
Yellow
3A
Red
0.5A
AUDIO OUT VIDEO VIDEO
OUT1 OUT2
L R
REMOTE
1
Ground
Connect to ground terminal.
2
Memory/Battery
+
Connect to battery or 12 volt
power source that is always
live. The radio will not work
if this wire is not connected.
3
Accessory/Ignition
Connect to existing radio
wire or radio fuse.
Audio/Video Connections
VIDEO 1
AUDIO INPUT 1
INPUT
L
DC12VIN DC12VOUT
+
NOTE: When replacing a fuse, be sure to use correct type and amperage to avoid damaging
the DVD player. The DV352 uses one 3 amp and one 0.5 amp ACG fuse, located in the black
filter boxes in-line with the power wires.
5
AUDIO OUT VIDEO
OUT1
R L R
REMOTE
VIDEO
OUT2