Ford 2014 FOCUS Owner's Manual page 270

M. Maximum Inflation Pressure: Indicates the tire manufacturer's
maximum permissible pressure or the pressure at which the maximum
load can be carried by the tire. This pressure is normally higher than the
vehicle manufacturer's recommended cold inflation pressure, which can
be found on the Safety Compliance Certification Label (affixed to either
the door hinge pillar, door-latch post, or the door edge that meets the
door-latch post, next to the driver's seating position), or Tire Label which
is located on the B-Pillar or the edge of the driver's door. The cold
inflation pressure should never be set lower than the recommended
pressure on the vehicle label.
The tire suppliers may have additional markings, notes or warnings, such
as standard load or radial tubeless.
Additional Information Contained on the Tire Sidewall for LT Type
Tires
B
D
B
A. LT: Indicates a tire, designated by the Tire and Rim Association, that
is intended for service on light trucks.
B. Load Range/Load Inflation Limits: Indicates the tire's load-carrying
capabilities and its inflation limits.
C. Maximum Load Dual lb (kg) at psi (kPa) cold: Indicates the
maximum load and tire pressure when the tire is used as a dual, defined
as four tires on the rear axle (a total of six or more tires on the vehicle).
D. Maximum Load Single lb (kg) at psi (kPa) cold: Indicates the
maximum load and tire pressure when the tire is used as a single,
defined as two tires (total) on the rear axle.
2014 Focus (foc)
Owners Guide gf, 1st Printing, October 2012
USA (fus)
Wheels and Tires
LT type tires have some additional
information beyond those of
C
P type tires. These differences
are described below.
Note: Tire Quality Grades do not
apply to this type of tire.
I n f o r ma t i o n P r o v i d e d b y :
269