Additional Information; Troubleshooting - Arcam BDP-190 User Manual

Additional
Information

Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . 30

Glossary . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . 34
Troubleshooting
If you experience any of the following difficulties while using
the player, use this troubleshooting guide to help remedy the
problem before requesting repairs. Should any problem
persist, consult your nearest retail dealer.
Picture
There is no picture/picture noise appears.
Re-connect the connecting cord securely.
The connecting cords are damaged.
Check the connection to your TV and switch the
input selector on your TV so that the signal from the player
appears on the TV screen.
The disc is dirty or flawed.
If the picture output from your player goes through your
VCR to get to your TV or if you are connected to a
combination TV/VIDEO player, the copy-protection signal
applied to some BD/DVD programmes could affect picture
quality. If you still experience problems even when you
connect your player directly to your TV, try connecting your
Depending on the disc, the picture quality may be poor
when the Resolution [settings>Display] setting is set to
progressive or HD TV using a component cord or an HDMI
cord. If this happens, switch Resolution to
When playing a double-layer DVD, the video and audio
may be momentarily interrupted at the point where the
layers switch.
There is no picture or picture noise appears
when connected to the HDMI OUT jack.
Try the following:
Turn the player off and on again.
1
Turn the connected equipment off and on again.
2
Disconnect and then connect the HDMI cord again.
3
If the HDMI OUT jack is used for video output, changing the
video output resolution may solve the problem.
The picture does not fill the screen, even
thoug
Display
The aspect ratio of the disc is fixed on your BD/DVD.
The dark area of the picture is too dark/the
bright area is too bright or unnatural.
TV Aspect Ratio
(default).
Sound
There is no sound.
The disc is dirty or flawed.
Re-connect the connecting cord securely.
The connecting cord is damaged.
The player is connected to the wrong input jack on the
amplifier (receiver)
30
put.
.
aspect
Display 16:9 Wide