Table of Contents
Advertisement
If parental control was already turned on, attempting to
change any of these items will first result in the following
screen appearing:
The first time this screen appears, you should enter the
default parental password, which is 0000. (This can be
changed later). Be advised that as you type these numbers,
*
numbers you are entering.
Once you enter the parental control password, you will be
automatically returned to the parental menu.
Parental ON/OFF
To turn parental control ON or OFF!
Parental Level
Use this menu item to restrict playback of disks encoded
with a rating level equal to or higher than the level you
set. Parental Control must be turned on for this menu
item to have an affect (see previous section).
To change the Parental Level, from the parental menu,
press the press the right arrow key until one of the
parental menu items (Parental Level, Parental Password,
Parental Control, or Parental Country) is highlighted.
Then, use the up or down arrow keys until the Parental
Level menu item is highlighted, as shown below:
Use the up or down arrow keys to highlight one of the
parental levels. Then, once the desired parental level has
been highlighted, press the Enter key to save your selection.
Parental Password
To change the parental control password, from the
parental menu, press the right arrow key until the
Parental Password menu option is highlighted, as
shown below:
Use the number keys on the remote to enter a 4-digit number
for the parental password. Once this number has been
then press the ENTER key.
Once a new Parental Password is saved, it must be
re-entered any time someone attempts to change an item in
the parental setup menu category.
SYSTEM Setup
[6]
press the
right arrow key until the System menu choice is
highlighted, as shown below:
Optical Disk AutoPlay
This option is used to tell the BD player whether or not to start
loading the main title menu of a disk as soon as the disk tray is
closed.
Screen Saver Duration
User can turn off this feature, or choose the duration to start
Screen saver picture (see the screen saver instruction for
details)
Auto Power Down
User can select desired time for tuning off, for instance,you
select 30 minutes, the player will be in standby mode after 30
munites.
Reset Settings
This setup menu selection will allow you to return all setup menu
choices to the factory default settings.
Press the ENTER key. The following screen will appear:
go back to the original factory settings. At same time, if above menu
is still on the screen, press RET key on the remote to exit please.
[7] NETWORK Setup
In order to access BD-live content, the BD player must be connected
to the Ethernet via the RJ-45 Ethernet connector on the rear of the
player.
press enter. The following screen will appear:
21
key. Once
changed settings from other menus will
option, and
Advertisement
Table of Contents
