Advertisement
Monitor will not power up – no backlight on power button
• Confirm 12v+ to monitor.
• Confirm ground connection.
• Check vehicle's fuse and circuit for proper operation.
No image on screen
• Verify cable is connected to monitor.
• Verify camera is connected to cable.
• Connect known good camera and cable to monitor.
o If image appears connect cable to existing camera.
Input does not trigger properly (Standby or otherwise)
• See owner's manual for proper wiring.
• Confirm 12v + to trigger lead.
o Note: Trigger will remain active as long as there is 12VDC+ to that wire,
preventing control or access to other inputs/cameras.
B. Woods
Tech Services
05.04.07
AOM561 Troubleshooting Guide
If image remains replace original cable.
If image disappears replace original camera.
Advertisement
Table of Contents
Need help?
Do you have a question about the AOM561 and is the answer not in the manual?
Questions and answers
Aom561, need Pinot diagram for cable from display to camera. Original cable cut and not available, thanks!